NetComm NTC-40WV User Manual page 83

Call Forwarding No Answer
Call forwarding No Answer will divert all incoming calls to a phone number that you desire only if the incoming call is not answered.
To enable Call Forwarding No Answer, dial *61*<Directory Number>#

(Where directory number is the number you wish to forward calls to)
Hang up after you hear 2 low pitch beeps.

To disable Call Forwarding No Answer, dial #61#

 Hang up after you hear 2 high pitch beeps.
To check the status of Call Forwarding No Answer, dial *#61# or view the advanced status page of the management console. Call
Forwarding No Answer is disabled if you hear 2 high pitch beeps. Call Forwarding No Answer is enabled if you hear 2 low pitch
beeps.
Call Forwarding Busy
Call forwarding busy will divert all incoming calls to a phone number that you desire only if your telephone is busy on another call.
To enable Call Forwarding Busy, dial *24*<Directory Number>#
(Where directory number is the number you wish to forward calls to)
Hang up after you hear 2 low pitch beeps.

To disable Call Forwarding Busy, dial #24#

 Hang up after you hear 2 high pitch beeps.
To check the status of Call Forwarding Busy, dial *#24# or view the advanced status page of the management

console.
o Call Forwarding Busy is disabled if you hear 2 high pitch beeps.
Call Forwarding Busy is enabled if you hear 2 low pitch beeps.
o
Call Forwarding Not Reachable
Call forwarding not reachable will divert all incoming calls to a phone number that you desire only if your telephone is unreachable by
the network.
 To enable Call Forwarding Not Reachable dial *62*<Directory Number>#
(Where directory number is the number you wish to forward calls to)
 Hang up after you hear 2 low pitch beeps.
 To disable Call Forwarding Not Reachable, dial #62#, Hang up after you hear 2 high pitch beeps.
 To check the status of Call Forwarding Not Reachable, dial *#62# or view the advanced status page of the
management console.
o Call Forwarding No Answer is disabled if you hear 2 high pitch beeps.
Call Forwarding No Answer is enabled if you hear 2 low pitch beeps.
o
Conference Call
This can be achieved by performing the following:
1. From the phone connected to the router, make a call to the 1st phone. Afterward perform a hook-flash (click "flash" button,
or briefly depressing the hook button) to put the 1st call on hold.
2. Call the 2nd phone number. After the 2nd phone picks up the call, place both calls into one conference call by performing
another hook-flash and then pressing button 3.
3. To terminate the conference call hang up the phone connected to the router.
www.netcommwireless.com
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
NTC-40WV HSPA+ M2M WiFi Router with Voice
83