Table of Contents
Advertisement
SNMP
The SNMP page is used to configure the SNMP features of the router.
SNMP (Simple Network Management Protocol) is used to remotely monitor the router for conditions that may warrant administrative
attention. It can be used to retrieve information from the router such as the signal strength, the system time, the interface status,
etc.
To configure SNMP:
1.
Select Enable for the "Enable SNMP" option.
2.
Enter Community Names or leave them as the default settings.
Community names are used as a type of security to prevent access to reading and/or writing to the routers configuration. It
is recommended to change the Community names to something other than the default settings when using this feature.
3.
Click the "Save" button to save any changes to the settings.
ITEM
Trap Destination (IP Address)
Heartbeat Interval (seconds)
Trap Persistence Time (seconds)
Trap Retransmission Time (seconds)
You can also trigger an SNMP Heartbeat manually by clicking the "Send Heartbeat Now" button.
NTC-40WV HSPA+ M2M WiFi Router with Voice
58
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Figure 60 - SNMP Settings
The IP Address SNMP data is to be sent to.
The number of seconds between SNMP heartbeats.
The length of time an SNMP trap persists.
The length of time between SNMP trap retransmissions.
Table 27 - SNMP Configuration Options
DEFINITION
www.netcommwireless.com
Advertisement
Table of Contents
