Table of Contents
Advertisement
Interfaces
The following interfaces are available on the NTC-40WV:
1
ITEM
1
Diversity Receive 3G Antenna
2
SIM Card Reader Tray Eject button
3
SIM Card Reader Tray
4
Main 3G Antenna
1
ITEM
1
WiFi Antenna Port
2
Captive Power Terminal
3
RJ-11 Telephone Cable Port
4
RJ-45 Ethernet Port
5
Reset button
NetComm Wireless NTC-40WV Industrial Indoor 3G Router with Voice
8
2
Figure 2 - Bottom Mounted interfaces
INTERFACE
Table 3 - Bottom Mounted interfaces
2
Figure 3 - Top Mounted Interfaces
INTERFACE
3
Connect one of the 3G antennas here
Push in with a paper clip to eject the SIM card reader tray.
Insert the SIM Card reader tray with a SIM inserted here.
Connect one of the 3G antennas here.
3
4
Connect one of the WiFi antennas here.
Connect the supplied power cable here.
Connect a PSTN telephone here in order to make calls via the 3G connection.
Connect an Ethernet cable here. The RJ-45 Ethernet port has two LEDs; a green LED
indicating the link status and an amber one indicating the speed of the link. When an
Ethernet cable is connected and the link LED is illuminated, the amber speed LED
illuminates to indicate a 100Mbps connection and extinguishes to indicate a 10Mbps
connection.
The reset button has multiple functions.
Reboot the device: Press and hold the reset button down for no longer
than 5 seconds. All LEDs remain off, when the button is released the green
LEDs flash once and the router reboots.
Reboot to recovery mode: Press and hold the reset button down for
between 5 and 15 seconds. When the LEDs are flashing, release the button
and the amber LED flashes. The router reboots into recovery mode.
Factory reset the device: Press and hold the reset button down for more
than 15 seconds. When all the LEDs are off, release the button. The Red
LED flashes to confirm the factory reset process. If you change your mind
after holding the reset button down for more than 15 seconds, you can
4
FUNCTION
5
6
FUNCTION
www.netcommwireless.com
Ver 1.4
Advertisement
Table of Contents
