Ac Input Power; Table 2.2 Power Cords - Xantrex XHR 7.5-130 Operating Manual

Installation

AC Input Power

AC Input Power
We warrant that the unit will perform to specification at AC input voltage range from
85 to 250 Vac. The power output derates to 900 W when the AC input voltage is
below 95 V.
AC Fail LED The AC Fail (ACF) LED turns on when the input voltage is outside
of the range specified for the power supply. The LED turns off when the input
voltage is within the range.
AC Input Cord We ship the power supply with an AC input cord rated for your
location. See
rated for your local voltage as long as it is within the supply's input range as stated
in
termination to mate with the power supply's AC input connector. If you need a
specific cord, call us.

Table 2.2 Power Cords

Location
North America
Asia
Great Britain
36
WARNING
There is a potential shock hazard if the power supply chassis and cover are not
connected to an electrical ground via the safety ground in the AC input
connector. Ensure that the power supply is connected to a grounded AC outlet
with the recommended AC input connector configured for the available line
voltage
CAUTION
!
When the power switch is turned on, the output voltage or current previously set
will be applied to loads
Table 2.2
"Input Conditions" on page
Power Cord Rating
125 V, 13 A NA plug
125 V, 13 A NA plug
250 V, 10 A British plug
for the list of power cords that we ship. Use a power cord
26. Any cord that you use requires a standard IEC 320
Operating Manual for XHR Series Power Supply