Figure 2.5 Output Connector - Xantrex XHR 7.5-130 Operating Manual

Installation
Load Connection
60 V to 600 V Models
The output connector for the 60 V to 600 V models is a 4-terminal, wire clamp
connector located on the rear panel. Two of the terminals are for local sense
connections. See
To prepare and connect the load wiring:
1. Strip insulation 0.35in. (9 mm) at the end of the wires.
2. Loosen the terminal screw, insert the stripped wire into the terminal, and tighten

Figure 2.5 Output Connector

44
WARNING
To protect personnel against accidental contact with hazardous voltages, ensure
that the load, including connections, has no live parts which are accessible. Also
ensure that the insulation rating of the load wiring and circuitry is greater than or
equal to the maximum output voltage of the power supply.
Figure
the screw securely.
Output
Connector
(For 60 V to 600 V models.)
2.5.
+
Operating Manual for XHR Series Power Supply
Load Wires