Ac Input Power Connection; Ac Input Connector; Ac Input Cord - Xantrex XPD 120-4.5 Operating Manual

Section 2. Installation

AC Input Power Connection

AC Input Power Connection
AC Input
The AC input connector is a standard IEC 15 A, 250 V male connector located on
Connector the power supply's rear panel. See
(7.5 V and 18 V), p.
AC Input
Cord
The AC input cord that we provide is appropriate to the country of destination. If you
require a special cord, contact us.
28
WARNING
There is a potential shock hazard if the power supply chassis and cover are not
connected to an electrical ground via the safety ground in the AC input
connector. Ensure that the power supply is connected to a grounded AC outlet
with the recommended AC input cord configured for the available line voltage as
described in this section.
WARNING
Disconnect AC power from the unit before removing the cover. Even with the
front panel power switch in the OFF position, live line voltages are exposed
when the cover is removed. Repairs must be made only by experienced service
technicians.
CAUTION
!
When the power switch is turned on, the output voltage or current previously set
will be applied to loads
13.
WARNING
The AC input cord is the disconnect device for the power supply. The plug must
be readily identifiable by and accessible to the operator. The input cord must be
no longer than 9.85 feet (3 m).
Figure 1.2 500 Watt Power Supply Rear Panel
Operating Manual for XPD Series Power Supply