Ac Input Power; Ac Input Voltage Selection - Xantrex XKW 8-125 Operating Manual

Installation

AC Input Power

AC Input Power
AC Input
Voltage
Selection
Before using the power supply, the correct AC input voltage must be selected and an
appropriate line cord and plug attached. All units are shipped in a configuration
requiring a 200-250Vac 10 A input. The unit can also be converted for use with a
100-130Vac 20 A input.
200-250Vac Input Connect a 250Vac 15 A plug and cord to the rear panel AC
connector and the safety ground screw.
Note: The NEUT. and LINE designations above the AC connector apply to the
100-130Vac 20 A input but do not apply to 200-250V operation.
28
WARNING
Exercise caution when using and servicing power supplies. High energy levels can
be stored at the output terminals on all power supplies in normal operation. In
addition, potentially lethal voltages exist in the power circuit and the output connector
of power supplies which are rated at 40V and over. Filter capacitors store potentially
dangerous energy for some time after power is removed.
WARNING
To provide protection for personnel in the case of unit failure and to ensure
proper power supply operation, the safety ground wire of the AC input line must
ALWAYS be connected to the ground screw provided.
WARNING
Attempted operation of the power supply with the incorrect input voltage may result in
internal damage to the unit.
Operating Manual for XKW 1kW Series Power Supply