Configuration And Operation; Start-Up; Main Menu; View Transmitter Status - Danish Interpretation Systems DCS 6000 User Manual

DIS
* Note that after selecting 'Stereo' as input mode
(step 14) the input
The next sections give descriptions of the
4.5

Configuration and operation

possible configuration options. Each description
is followed by the relevant menu items with
detailed information per menu option.
The default values (see section 'Reset all options
to factory defaults') are indicated by an asterisk
(*) when applicable.
When the transmitter is switched on, the display
4.5.1

Start-up

shows the Transmitter Status screen, which is
the first item of the Main menu.
The display also goes to this screen after 3
minutes of inactivity. In case the system detects
a fault, the display shows a flashing fault
message (see section 4.5.4).
The main menu contains the screens to view the
4.5.2

Main menu

transmitter status and the radiator fault status. It
also contains the entry points to the Monitoring,
Enquiry and Setup sub-menus.
Menu Item Transmitter Status Shows the transmitter status (see Item Description
section 4.5.3)
1 Fault Status Shows the radiator fault status (see
section 4.5.4)
2 Monitoring . . . Go to the 'Monitoring' sub-menu (see
section 4.5.5)
3 Enquiry . . . Go to the 'Enquiry' sub-menu (see
section 0)
4 Setup . . . Go to the 'Setup' sub-menu (see
sections 4.5.7 and higher)
Note: To enter the Setup sub-menu,
push and hold the button for at least 3
seconds
number changes
User Manual DCS 6000 Digital IR System rev H.docx
automatically to the next even number (12),
which is the input number of the left signal.
The first screen of the Main menu gives
4.5.3

View transmitter status

information about the present status of the
transmitter. The screen shows the name of the
transmitter (1st line)
transmission mode (2nd line). (See section 4.5.7
to change the transmission mode).
Transmitter Status
DT 6008
10 Channels
Options Description
Name The first line shows the name of the
transmitter
changing).
Modes The
transmission mode:
nn channels Audio signals are distributed on nn
channels.
Aux to All The signal on the Aux. inputs is distributed
on all channels.
nn Ch. Test The test signals are distributed on nn
channels.
Slave The transmitter operates in slave-mode:
the radiator signal on the slave input is
looped-through to all radiator outputs
Standby The transmitter is in standby mode (not
transmitting).
Emergency Call An emergency signal from the Aux. inputs
is distributed to all channels.
User Manual
and the present
(see section 4.5.17
second line shows the
for
actual
31