Danish Interpretation Systems DCS 6000 User Manual
Conference units
Hide thumbs
Also See for DCS 6000:
- User manual (66 pages) ,
- User manual (13 pages) ,
- User manual (59 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Danish Interpretation Systems DCS 6000
Summary of Contents for Danish Interpretation Systems DCS 6000
- Page 1 DCS 6000 User Manual Digital Conference System DCS 6000 Conference Units Danish Interpretation Systems...
- Page 2 Danish Interpretation Systems User Manual Copyright © 2005 DIS DCS6000_CONFERENCE_UNITS-REV-C.DOC 18-10-2005 No part of this publication may be reproduced or utilised in any form or by any means without permission in writing from the publisher.
-
Page 3: Table Of Contents
Chip Card functionality ........17 Repacking ............4 The use of Chip Cards........17 Warranty ............4 User Controls & Indications ......17 Description of the DCS 6000 system ....5 Connectors and interfaces.......18 Features.............. 5 System Setup............19 Central equipment & Interpreter equipment ... 5 General guidelines ...........19... -
Page 4: Important
Installation precautions Warranty Allow adequate air circulation to prevent internal The individual units in the DCS 6000 system are heat built-up.. minimum covered by 12 months warranty against Do not install the units in a location near heat defects in materials or workmanship. -
Page 5: Description Of The Dcs 6000 System
AMX or Crestron and conference microphone and voting facilities System components with attendance check with Chip Card ™. The DCS 6000 system consists of various units in • New, unique digital DATA and AUDIO bus. addition to the Conference Units. -
Page 6: Operating Instructions
DCS 6000 Conference Units • Fixed or detachable microphone General description • ON/OFF button The DCS 6000 Conference Units are fully digital • Built-in loudspeaker microcomputer controlled conference units. All • units includes a DSP processor (Digital Signal Language selector Processing). - Page 7 Danish Interpretation Systems User Manual CM/DM 6020P Portable Conference Unit Facilities: XLR microphone connector and loudspeaker The XLR connector is designed for use with GM 44xx series of microphones. CM/DM 6070P Portable Conference Unit Facilities: Fixed gooseneck, loudspeaker, two built-in channel selectors and two headphone connectors.
- Page 8 Danish Interpretation Systems User Manual CM/DM 6060F Flush Mounted Conference Unit Facilities: Fixed gooseneck, loudspeaker, one built-in channel selector and one headphone connector. Important: The CU 6000 does not support this unit CM/DM 6510F Flush Mounted Conference Unit Facilities: Fixed gooseneck, loudspeaker, 3 voting buttons and Chip-card reader, Important: The CU 6000 does not support this unit...
- Page 9 Danish Interpretation Systems User Manual CM/DM 6560F Flush Mounted Conference Unit Facilities: Fixed gooseneck, loudspeaker, 3 voting buttons, Chip-card reader, one built-in channel selector and one headphone connector. Important: The CU 6000 does not support this unit MU 6040C/D Microphone Unit Available in Delegate (D) and Chairman (C) version The MU 6040 Microphone Unit is designed for...
- Page 10 The AM 6040 Ambient Microphone Unit is designed for installation above a recessed ceiling for connection to an external microphone like DIS model HM 4042 or GM 44xx series of gooseneck microphones.. The AM 6040 is delivered in a shielded metal mounting box like the MU 6040.
-
Page 11: Microphone Functionality
Lights up with a red colour when the Microphone is a DCS 6000 Conference Unit to address an ON. If the microphone is muted, the light in the audience. The sound from a conference microphone light ring is turned off during the time the units is is called the ‘Floor’... -
Page 12: Operation Modes
Danish Interpretation Systems User Manual The “System Operation Mode” also called ‘CU Operation modes mode’ determines the behaviour of the microphone system. The mode is set on the CU 6000/CU 6010. System modes The following modes are available, when the CU The 6000 series microphones work in different 6000 or CU 6010 runs standalone (PC with SW modes - according to the settings of the system. - Page 13 Danish Interpretation Systems User Manual FIFO Interrupt First In First Out. The microphone unit functions in the same way as in automatic mode as long as the number of turned on delegate units is less or equal to the selected ‘maximum speakers’.
- Page 14 Danish Interpretation Systems User Manual Unit Operation mode Speak priority Interrupt ability Delegate unit Following ‘System mode’ 1 < Chairman unit Automatic < However for certain application, it is desirable to I.e. the following ‘Units’ can be created: assign ‘individual operations mode’, where the units will always follow the individual mode settings independently of the ‘System Setting’.
-
Page 15: Language Selection Functionality
Danish Interpretation Systems User Manual Language Selection functionality Language selection is a feature, where the delegate Headphone Connector (Molex) (only “F” can listen to either the floor (spoken) language or an models) interpreted language. A 2 pin Molex jack is located at the back for connecting a headphone for listening to the Floor User Controls &... -
Page 16: Voting Functionality
LED flashes together with the two other voting can cast their votes to various subjects using the LED’s the user can press any of the voting buttons DCS 6000 Conference Units. to cast a vote. The voting functionality is only available when the... -
Page 17: Chip Card Functionality
Delegate ID, Login Code and Location ID, which When a card is inserted in a conference unit, the the DCS 6000 system uses to identify the user of software will identify the user by matching the the Conference Unit by getting the personal details ‘Delegate ID’... -
Page 18: Connectors And Interfaces
Danish Interpretation Systems User Manual DCS LAN Connectors In addition to the connectors mentioned in the Two RJ45 sockets are located at the back of the previous section the following connectors are units for connecting to the previous unit (an IS available on all units: 6032/IS 6132 Interpreter set, CS 6032 Channel Selector, DM 6xxx Delegate Unit, the CU 6010... -
Page 19: System Setup
CU can be Settings switched ON. There are no settings to be done on the DCS 6000 After powering on the system, the light-ring in DCS conference units. The units are automatically 6000 Conference Units will flash until the CU recognized and receive a unique address in the identifies the unit. - Page 20 Danish Interpretation Systems Appendix Get the contrast adjustment tool, which has been shipped with your DCS 6000 Central Unit (see photo 1). A new adjustment tool can be ordered through your authorized DIS dealer. Order DIS p/n P0 45 00010.
- Page 21 Danish Interpretation Systems Appendix Potentiometer Photo 4 Turn the adjustment tool until the required contrast setting is obtained. Do not use excessive force when turning the tool, as this will cause the potentiometer to be damaged. Carefully extract the adjustment tool from the adjustment hole. Manual 01 18 04467...
-
Page 22: Accessories
Danish Interpretation Systems Appendix Accessories The following accessories are available for use with the DCS 6000 Conference Units: GM 44xx Gooseneck Microphones with XLR plug The gooseneck microphones are available in various lengths. To be connected to the XLR microphone... - Page 23 Danish Interpretation Systems Appendix HM 4047 Hand Microphone The HM 4047 Hand Microphone is identically to the HM 4042 except this model does not feature a light ring. Type Art No HM 4047 Hand Microphone....ZZDIS1050 DH 9001H Delegate Headphone This headphone is used with the built in channel selector.
- Page 24 Appendix CA 6000 cables Cat 5e Connection Cables (AWG24) The CA 6000 cables are use to connect the various units in the DCS 6000 system using the DCS-LAN connector: Type Art No EC 6000-..5 Connection Cable 0,5 m ..10 03 12500 EC 6000-01 Connection Cable 1 m ..10 03 13101...
-
Page 25: Appendix
HD15 connector Cabling The HD15 connector on the MU 6040 has the CAT5 following PIN layout: The DCS 6000 system uses CAT5, CAT5e or Signal Cable type CAT6 FTP or STP cables with screened RJ45 - Loudspeaker output DIS type: connectors. -
Page 26: Technical Specifications
Danish Interpretation Systems Appendix Technical specifications Digital Section General Microphone type..........Electret Cardioid Power requirement ..........24-48 V DC Microphone sensitivity ..........-22 DbV/Pa Power consumption............ 1W to 2W Max. SPL............125 dB (3% THD) Power supplied from CU 6000 / CU 6010 / EX 6010 / PS 6000 Equivalent noise ..........App.