Set Channel Quality And Assign; Inputs To Channels - Danish Interpretation Systems DCS 6000 User Manual

DIS
4.5.9

Set channel quality and assign

The audio quality of the channels (mono/stereo,

inputs to channels

standard/premium) can be set in sub-menu 4D.
The quality can be set the same for all channels
or for each channel separately. Note that
choosing stereo and/or premium quality uses
more bandwidth and decreases the number of
available channels (see section 3.2.4). In stereo
mode, the left signal is always an even numbered
input. The next higher input number is used for
the right signal. When the quality is set the same
for all channels with the 'All Mono' or 'All Stereo'
options, the inputs are assigned automatically to
the channels as indicated in the table below:
All Mono
Channel Input Channel
00 00
01 01
... ...
31 31
With menu option 4C (Per Channel Settings), the
assignment can also be done for each channel
separately.
4 Setup/4C Ch. Quality
4C Ch. Quality
All Mono SQ
All Mono SQ Options Set all channels to mono, standard quality. Description
All Mono PQ Set all channels to mono, premium quality.
All Stereo SQ Set all channels to stereo, standard quality.
All Stereo PQ Set all channels to stereo, premium
quality.
Per Channel . . . Select this option to go to the 'Per Channel
Settings' menu.
All Stereo
Input L Input R
00 00 01
01 02 03
... ... ...
15 30 31
User Manual DCS 6000 Digital IR System rev H.docx
4.5.9.1 Per Channel Settings
4 Setup/4C Ch. Quality
4C Channel 01
Mono SQ In 01
Options 4C Channel nn Description Select which channel to configure.
Channel nr. "nn":
Disabled In nn Disable selected channel.
Input nr. "nn":
Mono SQ In nn Set selected channel to mono,
standard quality.
Input nr. "nn":
Select the audio input that should be
distributed on the selected channel.
Mono PQ In nn Set selected channel to mono,
premium quality.
Input nr. "nn":
Select the audio input that should be
distributed on the selected channel.
Stereo SQ In nn Set selected channel to stereo,
standard quality.
Input nr. "nn":
Select the audio input that should be
distributed on the selected channel.
For stereo signals, the input number
of the left signal (even number)
should be selected.
Stereo PQ In nn Set selected channel to stereo,
premium quality.
Input nr. "nn":
Select the audio input that should be
distributed on the selected channel.
For stereo signals, the input number
of the left signal (even number)
should be selected.
Note: An asterisk (*) is shown behind the channel
number when the channel in the configured quality
does not fit on the available carriers (see section 3.2.4).
User Manual
{00 ... 31}
{00 ... 31}
{00 ... 31}
{00 ... 31}
{00 ... 31}
{00 ... 31}
35