Digital Receivers; Description - Danish Interpretation Systems DCS 6000 User Manual

DIS

6 Digital Receivers

The receivers are available for 4, 8 or 32
6.1

Description

channels. They can operate with a rechargeable
NiMH battery pack or with disposable batteries
and have controls for channel selection, volume
adjustment and an on/off push button. All
receivers have a 3.5 mm (0.14 inch) stereo jack
output socket for mono or stereo headphones.
An LCD display shows the channel number and
indicators for signal reception and low battery
power.
Charging circuitry is included in the receiver.
1. Charging
Figure 6.1-A Receiver, front view and back view
combination with the charging equipment.
indicator
2. Headphone connector - A 3.5 mm (0.14
inch) stereo jack output socket for the
- Used in
LED
User Manual DCS 6000 Digital IR System rev H.docx
headphone, with integrated Stand-by/Off-
switch.
3. LCD Display - A two digit display showing
the selected channel. An antenna symbol is
visible when the receiver picks up an infra-
red signal of adequate quality. A battery
symbol is visible when the battery pack or
the batteries are almost empty.
4. Volume control - A slider to adjust the
volume.
5. Channel selector - An up/down switch to
select an audio channel. The channel number
is shown on the LCD display.
6. On/Off button - When a headphone is
connected, the receiver switches to Stand-by
state. Pressing the On/Off button switches
the receiver from Stand-by to On. To switch
back to Stand-by, press and hold the button
for approx. 2 seconds. When the headphone
is removed,
automatically to the Off-state.
7. Battery pack connector - This connection is
used to connect the battery pack to the
receiver. Charging is automatically disabled
when this connector is not used.
8. Charging contacts - Used in combination
with the charging equipment to recharge the
battery pack (if used).
9. Battery pack or disposable batteries -
Either a rechargeable BP 6001 NiMH battery
pack or two disposable AA-size 1.5 V
batteries.
Note: When the receiver is not used, disconnect the
headphones. This ensures that the receiver is totally
switched-of and no energy is consumed from the
batteries or the battery pack.
User Manual
the receiver switches
45