Installation; Conference System; Connections; Connecting The Dcs 6000 - Danish Interpretation Systems DCS 6000 User Manual

DIS
3. Auxiliary audio inputs – Two female
XLR connectors for extra audio inputs.
They can be used to connect auxiliary
symmetrical audio signals such as a
music installation, the floor language or
emergency messages.
4. Audio signal inputs – 8 or 32 cinch
plugs to connect external asymmetrical
audio input signals. The number of
connectors depends on the transmitter
type.
5. Radiator signal loop-through input – A
HF BNC connector to loop-through the
radiator output of another transmitter.
6. Radiator signal outputs – Six HF BNC
connectors,
radiators. Up to 30 radiators can be loop-
through connected to each output. RG59
Cable must be used.
The transmitter can be placed on a table or
4.2

Installation

installed in a standard 19" rack.
When installing in a 19" rack the supplied 19"
brackets shall be fixed to the front side of the
transmitter by unscrewing the crews holding the
top and button cover and then fix the brackets
using the same screws.
This chapter gives an overview of typical system
4.3

Connections

connections using
transmitter:
Connecting the DCS 6000 Conference System
Connecting other external audio sources

Connecting an emergency signal switch

Connecting another transmitter


used to connect
the DT 60xx range
User Manual DCS 6000 Digital IR System rev H.docx
4.3.1

Connecting the DCS 6000

The transmitter is connected to DCS 6000

Conference System

Conference System directly to a CU 6105 or CU
6110 or to an AO 6004 or AO 6008 Audio Output
Unit. Each AO 6008 can feed up to 8 'Audio
Signal Inputs' in the transmitter.
the
Please refer to the individual DCS 6000 user
Figure 4.3-A
manuals for more information.
4.3.2 Connecting other audio
The transmitter has up to 32 audio inputs
sources
(depending on the transmitter type) to interface
with external asymmetrical audio sources, such
as congress systems from other manufacturers
or for music distribution.
The audio signals (stereo or mono) are
connected to the audio input cinch connectors.
Connecting the DCS 6000 Conference System.
User Manual
23