System Setup ............10 Repacking ............4 General guidelines ........10 Warranty ............4 Typical schematics ........10 DCS 6000 Conference System ......5 Using AO 6004 with DT 60xx Digital IR- Features ............5 Transmitter ..............11 3.2.1 Interpreter equipment ........ 6 System components ........
Warranty The individual units in the DCS 6000 system are You are cautioned that any changes or modifications minimum covered by 24 months warranty against not expressly approved in this manual could void defects in materials or workmanship.
‘in-rush’ current on the Mains • supply Features DCS 6000 Digital Conference System is a system to be Designed for 31 interpreted channels and 8 open used at meetings, where a number of people are microphones addressing the ‘Floor’ in a structured manor. The •...
System components The CU 6105/6110 Central Units support all available DM 6680 P Conference Unit (portable) with units in the DCS 6000 series: voting Central equipment etc. CM/DM 6080 F Conference Unit (flush mounted) EX 6010...
AO 6004 Audio Output Unit decode more channels. Easy to use with preconfigured settings and 4.1.1 The AO 6004 Audio Output Unit for the DCS 6000 General description automatic channel assignment at start-up: • system enables the user to record the sound from a Output A –...
User Manual 4.1.3 User controls, indications & connections The front plate layout of the AO 6004 Audio Output Unit consists of 4 XLR Analog transformer balanced outputs and 4.1.3.1 Front plate layout 2 DCS-LAN connectors: The output volume for each channel is +3 dB, which is Figure 0-A AO 6004 Back Panel the recommended level for connecting to DT 60xx.
User Manual During initialization unit will automatically assign channels to the outputs. The unit is immediately ready to use after start-up unless 4.1.5 Normal operation other channels need to be assigned to the outputs or Connect the AO unit(s) to the rest of the system via the channel volume needs to be adjusted.
650 m.. • • Typical schematics Connect the AO 6004 to the DCS 6000 network using interpreted channels or to a DT 6008 Infrared Cat 5 cables. The Analog Audio output connectors are Transmitter for transmitting the interpreted channels connected to either tape recorders for recording the wireless.
User Manual Using AO 6004 with DT 60xx Digital IR-Transmitter When using the AO 6004 with the DT 60xx Infrared The correct level on each connected channel on the Transmitter, the audio output level on the AO 6004 AO 6004 is +3dB. This level is factory preset, but can has to be set to match the sensitivity on the as earlier mentioned be changed using SW 6000.
6000........5 Deg C. to 40 Deg C. (35 to 80 % humidity) Specifications are subject to change without notice. Connection Details The DCS 6000 system uses Cat5e, Cat6 or Cat7 F/UTP DCS-LAN Chain Function Connector #1 Connector #2 or U/FTP cables with screened RJ45 connectors.
Danish Interpretation Systems User Manual The phase of the pairs must be correct and the wiring spec. as stated in Cat5e (EIA 568-B) have to be Analog Audio Out followed. XLR3 male Note: Cat6 and Cat7 cables can normally only be terminated in sockets (female) and not in cable plugs.
Need help?
Do you have a question about the DCS 6000 and is the answer not in the manual?
Questions and answers