DIS
The Monitoring sub-menu (2) is used to set
4.5.5
Set monitoring options
which signal is sent to the monitoring
headphone output. It can be one of the inputs,
one of the channels or no signal.
When the sensitivity of one of the inputs is being
changed in the Setup menu (4I, 4J or 4K), or
when assigning inputs to channels (menu 4C, Per
Channel), the monitoring output automatically
switches temporarily to that source, even when
the option 'None' has been chosen.
2 Monitoring
2 Monitoring
In. 04
-9 dB
In. nn
Options
dd dB
Description
The signal from audio input "nn" is
available on the monitoring headphone
output
Input nr. "nn":
Volume: "dd" dB
Ch. nn
dd dB
The signal on channel "nn" is available
on the monitoring headphone output.
Channel nr. "nn":
Volume: "dd" dB
Aux.L
dd dB
The signal on the Aux. Left input is
available on the monitoring headphone
output.
Volume: "dd" dB
AuxR
dd dB
The signal on the Aux. Right input is
available on the monitoring headphone
output.
Volume: "dd" dB
None
dd dB
The monitoring headphone output is
switched off during normal operation,
but is active when the sensitivity of one
of the inputs is being changed.
Volume: "dd" dB
{00 ... 31}
{-31 ... 0}
{00 ... 31}
{-31 ... 0}
{-31 ... 0}
{-31 ... 0}
{-31 ... 0}
User Manual DCS 6000 Digital IR System rev H.docx
When the headphone output is disabled (see
section 4.5.16), the output level can not be
changed and the level indicator is not visible.
The 'Source/volume' screen also displays level
meters (two for a stereo source, one for a mono
source) for a visual indication of the actual signal
strength
:
= low level
=
high
level
=
overflow.
In
the
Enquiry
4.5.6
View version information
information of the transmitter can be found. This
information should be mentioned in service
requests or failure reports.
3 Enquiry
3A Serial Number
FC.0.0012D
3A Serial Number
Options
Shows the serial number of the
Description
transmitter board.
3B HW Version
Shows the version number of the
transmitter board.
3C FPGA Version
Shows the version number of the
FPGA software of the transmitter
board.
3D FW Version
Shows the version number of the
transmitter firmware.
User Manual
sub-menu
(3),
version
33