Setup For Bindery Emulation - Oce VarioPrint 1105 User Manual

Print operations

Hide thumbs Also See for VarioPrint 1105:

Table of Contents

11.4.3 Setup for Bindery Emulation

Make sure of the Bindery Context.

Before connecting the print server (network interface card) to the Novell

NetWare 4.x-6 server of Bindery mode, make sure that the NetWare server

contains the bindery context.

If the bindery context does not exist, the network administrator should

modify the AUTOEXEC.NCF file to add an adequate SET command and

restart the NetWare server or enter a SET command from the console prompt

to make changes.

Note that any command entered following the console prompt is effective

immediately but the definition of the autoexec.ncf file becomes effective only

after turning off power and on again.

Setup with PCONSOLE in Bindery mode.

If you are sure that the bindery context exists in the file server, you can set

up the print server with PCONSOLE.

Refer to the Novell NetWare manual for details of setup with PCONSOLE.

In Bindery mode, only upper-case letters are valid for the printer server

Utility Tool

VarioPrint 1105