Oce VarioPrint 1105 User Manual page 141

Print operations

Hide thumbs Also See for VarioPrint 1105:

Table of Contents

PCL Printer Driver Setting (Windows)

Using two copiers (master copier and sub copier), prints can be made at the

same time under the same printing conditions. When printing a large number

of copies, time required to complete the job can be shortened.

The copier which receives the printing job instruction functions as the master

copier and the other one is the sub copier.

For the tandem printing, the two copiers should be connected by either

method as follows.

- Connect the two copiers directly with a cross cable. In this case, the

network functions cannot be used.

- Connect them with a straight cable via HUB.

Use a cross cable or straight cable higher than the category type 5.

Tandem printing should only be set up by your authorized service

representative.

Refer to the "User manual (Copier)" for more information about Tandem

Tandem Mode cannot be set in the following cases:

- When [Transparency Interleave] is selected in [Setup] tab.

VarioPrint 1105

Master Copier

Troubleshooting