ETC Lighting Control Console User Manual page 54

Record Confirm
This setting allows you to enable or disable the confirm action when storing over a previously
recorded target. The default is "Enabled".
Delete Confirm
This field allows you to enable or disable a required confirmation before any delete command is
executed. The default is "Enabled".
{ M a n u a l C o n t r o l }
This desk setting button gives you access to Element's manual control settings.
Manual Time
In this section you may change the default times for manual changes to occur in live. Times can be
set for Intensity Up and Intensity Down.
Manual Control
This section allows you to specify the values for certain buttons and settings used in manual
control. To change any value, click the appropriate button in the CIA and use the keypad to enter a
new value.
Preserve Blind Cue - This enables the console to display the last selected cue in blind
when you return to blind. The default is disabled.
Level - This sets the default for Level (which is accessed in Element by double pressing
[At]). Any value between 0-100 may be entered. The default is 100.
Plus% - This sets the level for the +% (which is accessed in Element by pressing [Shift] &
[+]), which will increase the selected channel by the set percentage. Any value between 0-
100 may be entered. The default is 10%.
Minus% - This sets the level for -% (which is accessed by pressing [Shift] & [-]), which will
decrease the selected channel by the set percentage. Any value between 0-100 may be
entered. The default is 10%.
Rem Dim Level - This allows you to set the level for all Remainder Dim commands. The
default is 0.
Default Times
In this section you may change the default times for sneak commands, back time, and go to cue
time. The default for these is 5 seconds, except for back time, which uses a default of 1 second.
{ F a c e P a n e l }
In this section you may change the sounds settings as well as adjusting the increment and
acceleration effect of the level wheel.
{ F a c e P a n e l K e y p a d }
Auto Repeat
This setting allows you to adjust the auto repeat settings (delay and speed) for the facepanel
keypad.
Blackout
You can disable the [Blackout] hardkey here. By default, blackout is "Enabled".
Grandmaster
You can disable the Grandmaster. By default the Grandmaster is "Enabled".
Spacebar [Go]
You can enable the spacebar on an external keyboard as the hotkey for [Go]. By default, it is
"Disabled".
42 Element User Manual