ETC Lighting Control Console User Manual page 246

S u b n e t M a s k
If DHCP is disabled, you set the Element subnet mask here. This is a static setting and will remain
set until changed by a user. Element's default subnet mask is 255.255.0.0.
If DHCP is enabled, this field will display the subnet mask that is being used by the desk (whether
it is served via DHCP or a self-generated link-local IP address).
G a t e w a y
If DHCP is disabled, you set the gateway IP address here. This is a static gateway IP address and
will remain set until changed by a user. Element's default gateway is 10.101.97.101.
If DHCP is enabled, this field will display the gateway IP address that is being used by the desk
(whether it is served via DHCP or a self-generated link-local IP address).
P h y s ic a l A d d r e s s
The physical address is the MAC address. This address is a unique identifier and cannot be
modified.
E n a b l e R e m o t e P o w e r O n / O f f
It is possible to remotely power on and off RVIs and Element
{Remote Power On} and {Remote Power Off} must be enabled on each device before it can
receive the power on and off commands. The default setting for both is Disabled.
The Remote Power commands are sent from the browser. The command for Power On is sent from
Browser>Network>Power On MultiConsole System, and the command for Power Off is from
Browser>Network>Power Off MultiConsole System.
P i n g
Ping is used to test the network connection between two devices.
Click to enter the IP
address of the
device you want to
ping, and then press
{Start}.
234
Device is responding to the
ping.
Device is not responding to
the ping.
Element User Manual