ETC Lighting Control Console User Manual page 267

C o n n e c t i n g t o E l e m e n t
There are some additional steps for connecting to an Eos Family network.
Step 1: Follow the steps for installing the Eos Family offline software.
Step 2: Change the IP address, subnet mask, and gateway of the PC to match the Eos Family
system IP address scheme. It is recommended that you use the IP address of
10.101.1.101, subnet mask of 255.255.0.0, and gateway of 10.101.0.1.
N o t e :
For Windows Vista, these additional steps are needed:
Step 3: Go to Control Panel>User Accounts>Turn User Account Control On or Off
Step 4: Uncheck "Use User Account Control (UAC) to help protect your computer" and
then click "Ok".
Step 5: Reboot your computer.
N o t e :
E
Mirror Mode
You may need to restart your computer after changing the IP address. If you can't
connect after doing that, check to make sure Windows Firewall has been turned
off.
Windows 7 is not currently fully supported. Please see
www.etcconnect.com/support.aspx
available.
http://
for updated information as it becomes
255