ETC Lighting Control Console User Manual page 187

{Device Details} - appears when the current address is patched to a RDM device. RDM devices
must be enabled through the ECU and discovered through the patch. See
and {Patch} Display and Settings, page
{Device Details} displays the information that it receives from the device and allows some changes
to be made to:
N o t e :
• Device Label (displayed at the top by the address number)
• DMX Address (can be changed in this display by clicking on the property or value)
N o t e :
N o t e :
• DMX Label (same as the device label, but the label can be changed here by clicking on
the property or value)
• Type
• Manufacturer
• Device ID
• Footprint
• Version
• Lamp State
• Lamp Hours
• Head DC Voltage
• Lamp On/Off
• Gel Distance Traveled
• Gel2 Distance Traveled
• Fan RPM
• Ambient Temperature
• Gel Temperature
• Device Errors (will only display if there are current errors)
• Clear Errors
Device Errors are displayed in four different colors depending on severity. The severity of the error
is determined by the manufacturer of the device.
• Gray - Unknown or not an error
• White - Advisory
• Yellow - Warning
• Red - Error
14
Using About
61.
Changes may take a few seconds to take effect. They will propagate to the RDM
device and then back to the console's patch and about displays.
You may change the starting address on RDM devices, but the port/universe is
fixed by the device's connection to the gateway. To change the universe., the
device must be connected to a different gateway port in the system.
Details displayed will vary based on the device.
Enable RDM, page 236
175