Table of Contents
Advertisement
To Set Up a Playback Loop...
1.
Set the loop start and end times in one of the following ways:
•
Drag the mouse between two points in the time ruler of the
Track, Piano Roll, Staff, or Audio view to select a range of
times, then click
the selection time to the loop time
•
Click between two markers in the Track, Piano Roll, Staff, or
Audio view to select a range of times, then click
Loop/Auto Shuttle toolbar to copy the selection time to the
loop time
•
Type the loop start and end times directly into the toolbar
•
Select a range of times, then right-click in the time ruler and
choose Set Loop Points (this method makes step 2
unnecessary)
2.
Click
to turn looping on.
To Change the Loop Settings...
1.
Click
, or choose Realtime-Loop and Auto Shuttle to display
the Loop/Auto Shuttle dialog box.
2.
Check the options you want to use.
3.
Click OK.
To Cancel a Playback Loop...
1.
Click
on the toolbar to disable looping.
in the Loop/Auto Shuttle toolbar to copy
in the
3-9
Advertisement
Table of Contents
Troubleshooting
