CAKEWALK PRO AUDIO User Manual page 580

I-12
Mixer Button or Control...
Red fader—This is the master
fader. It controls overall level
for both playback and
recording.
Rec Adjust knob—Moving
this knob makes fine
adjustments to the record
level.
Rec Monitor—When this
button is highlighted (yellow),
only the sounds you are
sending to the computer to
be recorded play through U-
8's outputs. This is for
checking what you are
recording.
Direct button—When this
button is highlighted (yellow),
the Mixer sends the signal to
the computer without effects.
Master meter—The Master
meter measures playback
volume through U-8's
outputs. When the Rec
Monitor button is highlighted,
the Master meter measures
the level of sounds the Mixer
sends to the computer for
recording.
Record buttons—Use these
four buttons (Inst, Aux, Mix,
Wave 2 EFX) to choose
which signal to send to the
computer to be recorded.
Effect Window—Press this
button to open the Effects
window.
Check button—Press this
button to hear only the
effects signal.
How to Control It...
Move U-8's red Master fader.
Move the Cursor buttons until the blue frame
encloses the Rec Adjust knob. Use any Effects/
Mixer Control knob to choose values.
Press U-8's Rec Monitor button to turn the
Record Monitor on or off.
Move the Cursor buttons until the blue frame
encloses the Direct button. Press U-8's Enter
button. Note: The Direct button does not
respond unless an Insert button is highlighted
and either Inst or Aux is highlighted under
Record.
The Master meter is always on.
Move the Cursor buttons until the blue frame
encloses the desired Record button, and press
U-8's Enter button to highlight the desired
button.
Press U-8's Effects button to either open or
close the Effects window.
Move the Cursor buttons until the blue frame
encloses the Check button, and press U-8's
Enter button.