Table of Contents
Advertisement
To Create a Custom Group...
1.
Right-click on any control in the group and choose Group
Properties to display the Group Properties dialog box.
2.
Choose Custom as the group type. The starting and ending values
for each control are displayed.
3.
To change the starting or ending value for a control, click on the
control in the list and enter new values in the Start and End box.
4.
To swap the starting and ending value, click the Swap button.
5.
Click Close when you are done.
Pro Audio uses the type to determine the range of motion for the
group's controls.
To Adjust the Start Value of a Control...
1.
Set the control to the desired starting value.
2.
Right-click on the control.
3.
Choose Set Start-Current .
Pro Audio sets the start value of the control.
To Adjust the End Value of a Control...
1.
Set the control to the desired ending value.
2.
Right click on the control.
3.
Choose Set End-Current .
Pro Audio sets the end value of the control.
Using Remote Control
Pro Audio lets you use a MIDI device to remotely control knobs, buttons,
and sliders in the Console view. For example, you can:
¥
Use a key on your keyboard to temporarily mute a track
¥
Work the send level in an aux bus with your pitch bend wheel
¥
Set the main volume levels with NRPN messages
If you set up remote control for a grouped control, the remote control
works all controls in the group.
9-23
Advertisement
Table of Contents
Troubleshooting
