Searching for the Frequency of the
Tone Squelch Used by the Remote Station
The frequency of the tone squelch used by the remote station can be searched for and
displayed.
Press the M key more than 1 second.
1
The Set mode is selected.
Turn the O knob to select "4 SIGNALING".
2
Press the M key briefly.
3
Turn the O knob to select "11 SQL TYPE".
4
Press the M key briefly.
5
Turn the O knob to select "TONE SQL".
6
Press the M key briefly.
7
8
Receive the signal from the remote station.
Press the B key more than 1 second.
9
"TONE SEARCH" is displayed.
Release the B key.
10
Search for the tone frequency starts.
When a coincident frequency is detected, a beep is emitted and search stops
temporarily. The detected tone frequency blinks.
Hints
To set the found tone frequency, use the following procedure:
Press the B key.
Press the M key more than 1 second again.
The Set mode is canceled.
Hint
For the operation to perform when scanning stops, refer to "Selecting a Reception Method When
Scanning Stops" (See page 57).
Selecting a DCS Code
You can select a DCS code from among 104 DCS codes (023 to 754) (See page 170).
1
Specify the operating frequency.
Press the M key more than 1 second.
2
The Set mode is selected.
Turn the O knob to select "4 SIGNALING".
3
Press the M key briefly.
4
Turn the O knob to select "2 DCS CODE".
5
Press the M key briefly.
6
Turn the O knob to select a DCS code.
7
Press the M key more than 1 second.
A beep is emitted.
FCC
IC:
Using the Tone Squelch Function
YAESU
MUSEN
ID:
K6620445X20
511B-20445X20
71
CO.,
LTD.