Repeater Operation
Communicating Via the Repeater
The FT1DR supports an ARS (Automatic Repeater
Shift) function which allows you to perform
communication automatically just by setting the
reception frequency to the repeater frequency.
1
Set the reception frequency to the repeater
frequency.
"TN " is displayed in the upper right corner of the
LCD.
While pressing the p switch, perform transmission.
2
Hints
• Pressing the F key, and then pressing the 5 key. This produces the "reverse" state where the
transmission frequency and the reception frequency are temporarily reversed, allowing you to check
whether you can communicate with the remote station directly.
• In the "reverse" state,
• Press the F key, and then press the 5 key again. This cancels the "reverse" state.
• Press and hold the M key over 1 second to change the Set mode. This allows you to use the
repeater more conveniently.
"7 CONFIG"
"14 RPT ARS" You can deactivate the ARS function.
"7 CONFIG"
"15 RPT SHIFT" You can set the repeater shift direction.
"7 CONFIG"
"16 RPT SHIFT FREQ" You can change the repeater shift step.
38
Repeater Operation
Repeater Operation
blinks on the LCD.
FCC
ID:
K6620445X20
IC:
511B-20445X20
YAESU
MUSEN
CO.,
LTD.