Basic Operation; Preparation; Installing The Antenna; Attaching The Supplied Belt Clip/Protective Cap - Yaesu FT1DR Operating Manual

Preparation

Installing the Antenna

1
Align the antenna with the antenna terminal on the main unit.
Note Be sure to hold the thick root of the antenna when installing it.
2
Turn the antenna clockwise until it is secured.
Precaution
z Do not hold the upper part of the antenna when installing or removing it.
Breaking of wire can occur inside the antenna.
z Do not transmit without installing the antenna. The transmitter circuit can
be damaged.
z When using an detachable antenna other than the supplied one or any
other external antenna, ensure that its SWR is adjusted to 1.5 or lower.

Attaching the Supplied Belt Clip/Protective Cap

Attaching the Protective Cap

1
Attaching the Protective Cap
If you do not use the belt clip, attach the protective cap
to the belt clip attaching opening.

Installing the Belt Clip

1
Turn over the battery pack.
2
Install the belt clip using the supplied screws (two).
Precaution
z Be sure to use the supplied screws when installing the belt
clip. Using any other screws can result in injury, damage to
parts, and other troubles.
z Be sure to install the protective cap when the belt clip is not
used.

Basic Operation

Basic Operation
FCC ID: K6620445X20
IC: 511B-20445X20
YAESU MUSEN CO., LTD.
15