Selecting A Tone Frequency - Yaesu FT1DR Operating Manual

Using the Tone Squelch Function
Display
PAGER (See page 124)
D CD*
TONE-DCS*
D CD-TONE SQL*
* Press the M key more than 1 second to select the Set mode and selecting "4 SIGNALING"
SQL EXPANTION"
mode items "4 SIGNALING" to "16 SQL TYPE", allowing you to select different types of squelches for
transmission and reception.

Selecting a Tone Frequency

You can select a tone frequency from among 50 frequencies (67.0 Hz to 254.1 Hz)
(See page 181).
1
Specify the operating frequency.
Press the M key more than 1 second.
2
The Set mode is selected.
Turn the O knob to select "4 SIGNALING".
3
Press the M key briefly.
4
Turn the O knob to select "12 TONE SQL FREQ".
5
Press the M key briefly.
6
Turn the O knob to select a tone frequency.
7
Press the M key briefly.
8
The selected tone frequency is determined.
Press the M key more than 1 second.
9
The Set mode is canceled.
Hints
• The tone frequency selected using the above-described procedure is also effective when only the
tone is sent out.
• By default, the tone frequency is set to 88.5 Hz.
70
Turns on a new pager function ("PAG" is displayed).
When using FT1DRs with your friends, specifying personal codes (each
code is composed of two tones) allows only a specific station to be
called.
Sends a DCS code only in case of transmission ("DC" is displayed).
Sends a tone signal in case of transmission, and waits for a DCS code in
case of reception ("T-D" is displayed).
Sends a DCS code in case of transmission, and waits for a tone signal in
case of reception ("D-T" is displayed).
"ON" will add options "D CD", "TONE-DCS", and "D CD TONESQL" to the Set
FCC
IC:
Operation
YAESU MUSEN
ID: K6620445X20
511B-20445X20
"10
CO., LTD.