Scanning Function; Using The Scanning Function; Vfo Scan - Yaesu FT1DR Operating Manual

Using the Scanning Function

The FT-1DR supports the following four scan modes:

(1) VFO Scan

(2) Memory Scan
(3) Programmable Memory Scan
(4) Selected Memory Channel Scan
VFO Scan
1
Select the VFO mode, and then select a band to scan.
While pressing the B key, turn the O knob to specify the scanning range.
2
Specify the scanning range as follows.
Display*
ALL
(PMS
number)
± 1 MHz
± 2 MHz
± 5 MHz
BAND
Release the B key.
3
Scanning (SCAN) starts toward higher frequencies.
While the B key is pressed down, the scanning range is displayed on the LCD.
Hints
When a signal is received during scanning, the decimal point blinks.
Turn the O knob clockwise.: Scanning is performed toward higher frequencies.
Turn the O knob counterclockwise.: Scanning is performed toward lower frequencies.
When a signal is received during scanning, a beep is emitted and its frequency is displayed
for 5 seconds. When scanning is suspended, the decimal point blinks and the LCD stays lit.
After receiving the signal for 5 seconds, scanning resumes.
Precaution
The difference between the upper limit frequency and the lower limit frequency for PMS must be 100
kHz or more.
48

Scanning Function

Scans all bands within the range from the current frequency to 108-999 MHz.
Shortcuts the PMS scanning procedure (steps 1 and 2 described on page 46).
If PMS memories have been registered in advance, PMS memory numbers are
displayed. Turn the O knob to select the PMS memory you want to scan, and then
scan the PMS range.
Scans the current band (see the table on the next page) within ± 1 MHz of the
current frequency.
Scans the current band (see the table on the next page) within ± 2 MHz of the
current frequency.
Scans the current band (see the table on the next page) within ± 5 MHz of the
current frequency.
Scans the current band (see the table on the next page) starting with the current
frequency.
Operation
YAESU
FCC ID: K6620445X20
IC: 511B-20445X20
MUSEN CO., LTD.