Attaching A Hand Strap; How To Use The Battery Case (Fba-39) (Option) - Yaesu FT1DR Operating Manual

Preparation

Attaching a Hand Strap

If you attach a hand strap to the FT1DR, its string which is inserted in and secured to
the strap hole in the transceiver must have a diameter of 1 mm.
* The hand strap does not come with the FT1DR.
1
Remove the battery pack.
2
Attach the hand strap.
Precaution
Use a hand strap which can stand the weight of the FT1DR.
If you use a hand strap which is not strong enough, the hand strap can
break and the FT1DR can fall down, resulting in injury, damage to parts,
and other troubles.

How to Use the Battery Case (FBA-39) (Option)

The optional battery case (FBA-39) allows three AA Alkaline batteries to be used as a
power supply.
Hint
When the battery case (FBA-39) is used, you can select a power output level from:
Low Power (L1): 0.05 W
Low Power (L2): 1W
Note that Low Power (L3) and High Power are not available.
1
Open the cover.
Lift up the lower right corner indicated by the hand pointer in
the illustration.
2
Put alkaline batteries in the battery case.
Note Use three alkaline batteries. Pay attention to polarities (+ and í)
of the alkaline batteries.
3
Close the cover.
Push hard four corners of the cover to close it tightly.
Hint
When the batteries become weak, _ is displayed on the LCD. When
the batteries become far weaker, _ blinks on the LCD.
16
FCC ID: K6620445X20
IC: 511B-20445X20
YAESU MUSEN CO., LTD.