Communication
Let's try communication using the FT1DR in the analog communication mode.
Follow the procedure below.
Turning on the Power
Press and hold the P switch over 1 second.
1
An opening message is displayed, and then two frequencies (A-band frequency and
B-band frequency) are displayed at the same time.
Hints
You can change the information such as the power supply voltage and the opening message
displayed at power-on. Press and hold the M key over 1 second to select the Set mode, and
then select "1 DISPLAY"
In addition, you can cause the FT1DR to display the reception frequency immediately without
displaying the opening message (See page 154).
O Turning off the Power
To turn off the power, press and hold the P switch over 1 second.
Turn the power on.
Adjust the volume level.
Select an operating band.
Select a frequency (band).
Tune in to a frequency.
Start communication.
"7 OPENING MESSAGE".
FCC
ID:
K6620445X20
IC:
511B-20445X20
YAESU
MUSEN
CO.,
LTD.
23