Writing Into The Memory - Yaesu FT1DR Operating Manual

A Wide Variety of Memory Functions

Writing into the Memory

Precaution
The stored data can be erased due to wrong operation, static electricity, or electrical noise.
Also, it can be erased in the case of a failure or repair. Be sure to write it down on paper or the like.
The FT1DR allows you to use 900 channels (memory channel numbers 1 to 900).
1
Select the VFO mode.
Turn the O knob to select a frequency.
2
Select the frequency you want to write into the memory.
Press the F key more than 1 second.
3
The Memory Write mode is selected, and the number of
the memory channel next to the memory channel for which
you stored a frequency last blinks.
• To cancel the memory write operation, press the p
Remarks
switch.
• To store a frequency with a memory channel specified, turn the O knob to select the
memory channel
[The specified channel is unregistered] ( icon is displayed, and the memory channel
blinks.
[The specified channel is registered] ) icon is displayed, and "OVERWRITE OK?" is
displayed on the LCD.
• Pressing the M key allows you to skip channels quickly in steps of 100 channels.
Press the F key briefly.
4
The memory write operation is completed, and the registered frequency is displayed
on the LCD.
Hints
• By default, 145.000MHz was registered to memory channel 1. It can be changed to another
frequency, but cannot be deleted.
• The frequency which has previously been registered to a memory channel can be overwritten with a
new frequency.
When you intend to write a new frequency into the memory, an unregistered memory channel is
displayed.
• To display the lowest unregistered memory number when you start writing into the memory, press
the M key more than 1 second to select the Set mode, and then select "3 MEMORY"
MEMORY WRITE".
• To inhibit writing into all memories, press the M key more than 1 second, and then select "3
MEMORY" "4 MEMORY PROTECT".
40
FCC ID: K6620445X20
IC: 511B-20445X20
"6
YAESU MUSEN CO., LTD.