Table of Contents
Advertisement
(2)
Form Feed Controls
CODE:
FF
PURPOSE:
FORMAT:
REMARKS:
REFERENCE:
CODE:
ESC C n
PURPOSE:
FORMAT:
REMARKS:
REFERENCE:
CODE:
ESC CO
PURPOSE:
FORMAT:
REMARKS:
REFERENCE:
CODE:
ESC
R
n
PURPOSE:
FORMAT:
REMARKS:
REFERENCE:
CODE:
ESC N
n
PURPOSE:
FORMAT:
REMARKS:
REFERENCE:
n
Advance the paper to the next top of form
CHR$(l2)
When this command is received by the printer, it causes
the paper to be advanced to the top of the next page or
form.
The initial default value of the page is set to 11 inches
or 12 inches according to DIP switch, but can be changed
using the ESC C n and the ESC COn code.
ESC C n, ESC COn
Change the setting of the page (form) to n lines
CHR$(27) CHR$(67) CHR$(n)
When this code is received, the length of the page is set-
to
n
lines.
The value of n must be between
1
and
127.
ESC COn
Change the setting of the form length to n inches
CHR$(27) CHR$(67) CHR$(O) CHR$(n)
When this code is received, -the length of the page is set
to n inches.
The value of n must be between 1 and 32.
ESC. C n
Change the line location of the header (first line) of the form
CHR$(27) CHR$(82) CHR$(n)
This command is used to change the location of the first line
on the next page or form.
The location of the first line is given by the value of n,
and must be between
1
and
16.
The default value set upon "power on" or printer reset is
n
=
1.
ESC
0
Set the skip-over perforation feature
CHR$(27) CHR$(78) CHR$(n)
When this command is received, the skip-over perforation
is activated.
This feature causes the printer to skip to the next page
or form, when the number of lines left on the page is
equal to n.
The value of n must be between 1 and 127.
ESC 0
-44-
Advertisement
Table of Contents
