Star Micronics gemini-10X User Manual page 19

Fig. 1-20 Installing Roll Paper
(10) When the paper has been pushed through so it's above the paper press,
push the press back so it's in its operational position (that is, flush
against the paper).
(11) Adjust the paper, if necessary, so it will feed through straight; then,
push the release lever back to the "locked" or "closed" position, marked
with the letter "F".
(12) Lower the paper separator, as shown in Fig. 1-21.
Fig. 1-21 Adjusting Roll Paper
(13) Rotate the platen knob and check to see if the roll paper is feeding
smoothly. If some adjustment is needed, pull the release lever forward
to the "open" mode again, and adjust the placement of the paper before
"closing!! the release lever.
(14) Set the print-start position, and replace the cover.
-10-