Table of Contents
Advertisement
5-2-2
Replacement of Fuse
If the printer is not operating and the indicator lamp does not light
although the printer is connected to a power source and the power switch
is turned on, first check the fuse.
(1) Remove the upper case of the printer as described in section 5-2-1.
(2) Check the fuse on the fuse board near the power switch.
(3) If the fuse is blown, replace it with a 1.25A/125V slow-blow type fuse.
(4) After check and replacement of the fuse have been completed, reassemble
the upper case etc. in the reverse procedures as before.
Lower Case
Fuse Board
Power Switch
Fig. 5-2
Replacement of Fuse
-57-
Advertisement
Table of Contents
