Table of Contents
Advertisement
1-9-3
Inserting Sprocket Paper
(1) Tu:cn the power of f and remove the printer cover.
(2) Install the tractor unit, as described in section 1-5-2.
(3) Install the paper separator and paper guide, as described in section 1-6.
(4) Pull the release lever, located on the left side of the printer, toward
the "open" position (marked fiT").
(5) Lift up the paper press.
(6) Pull the paper separator upright, as shown in Fig. 1-22.
Paper
separator~
~I
Fig. 1-22
Installing Sprocket Paper
(7) Place the stack of sprocket paper behind the printer.
aper Guide
(8) Pick up the top sheet of paper and feed it between the paper chute and
platen cover, from the back side of the platen.
(9) Push the paper down and forward, so it wraps around the platen.
(10) Return the paper separator to its original position.
(11) Open the tractor covers, atop the right- and left-sprocket mechanism,
as shown in Fig. 1-23.
(12) Pull the paper up, past the sprocket mechanism.
(13) Flip the clamp levers forward on the sprocket mechanism; adjust each
mechanism (right and left) so that the sprockets (the nubby little
"teeth" sticking out on the sprocket wheel) align with the holes on
the paper.
(14) Adjust the sprockets so they are lined up with the sprocket holes.
-17-
Advertisement
Table of Contents
