Table of Contents
Advertisement
1-9-2
Inserting Roll Paper
(1) Turn the power off and remove the printer cover.
(2) Remove the tractor unit, if you have not already done so.
(3) Following the procedures described in sections 1-6 and 1-7, install
the paper separator, guide, and holder.
(4) Pull the release lever (located on the left side of the printer) into
the "open" position.
As with single sheet paper, the "open" position
is indicated by the letter "T".
(S)
Lift up the paper press.
(6) Pull the paper separator upright, as shown in Fig. 1-19.
The paper guide should remain horizontal.
(7) Insert the roll paper, as shown in Fig. 1-19, so that when viewed from
the printer's right side, the paper will unroll in a clockwise direction.
Paper Separator,
Release Lever,
Paper Press \
Fig. 1-19
Setting Roll Paper
,Roll Paper
Paper Holder
(8) As shown in Fig. 1-20, unroll some paper and pass it above the paper
guide, and underneath the up-ended paper separator.
(9) Insert the roll paper into the paper chute, then push the paper through
so that it goes around the platen.
-15-
Advertisement
Table of Contents
