Paper Separator
\
Tractor Cover\
\
Paper
Fig. 1-23
Installing SprQcket Paper
(15) Close the tractor covers and snap the clamp levers back into the "locked"
position.
(16) Rotate the platen knob, and roll the paper up or down until the correct
"print-start" position is obtained.
Clamp Lever
Fig. 1-24
Adjusting Sprocket Paper
(17) When the paper installation is completed, replace the printer cover
and turn the power on.
(Note)
If you use multi-layer paper (such as a three-sheet carbonless form)
with this printer, you'll adjust the print gap, as discussed in section 1-10.
-18-