Using The Ts-350I Phone; Receiving A Call; Placing A Call - Talkswitch TS-350i User Manual

USING THE TS-350i PHONE

RECEIVING A CALL

When you receive a call, the phone rings while the LCD displays the incoming call information and the
associated extension button flashes.
To answer an incoming call:
• Lift the handset. You may press the
speakerphone. To use a headset, press the headset button.
To end a call:
• Hang up the handset. If using the speakerphone, press the
button.
To refuse a call:
• Press the Refuse softkey. The phone system or service will handle the call according to the 'busy'
settings.

PLACING A CALL

Calls can be placed with the handset on-hook or off-hook. This is similar to a mobile phone. The phone
supports a technique called 'store and forward dialing' . After you dial a digit, the IP phone waits about
5 seconds for additional digits. If you do not dial additional digits, the phone sends the digits you dialed
to the phone system for processing. When done dialing, press the Dial softkey or # key to place the call
immediately.
To place a call:
• Lift the handset or press the
press the button.
• Dial the destination number. After a short delay, the phone will send the number. Optionally, press
the Dial softkey or press # to place the call immediately.
• When connected to the remote party, the LCD displays the elapsed call time and provides softkey
options for call control.
To end a call:
• Hang up the handset. If using the speakerphone, press the
button.
6 0
button, line button or the Answer softkey to activate the
button or line button to activate the speakerphone. To use a headset,
button. If using the headset, press the
button. If using the headset, press the
T S - 3 5 0 i U S E R G U I D E