Talkswitch TS-350i User Manual page 47

• Call Waiting Tone: When enabled, a tone is played to the user along with Caller ID information to
announce the new call.
• Call Hold Ringback: When enabled, the phone rings if the user has taken a 2nd call then terminated
the call with another caller still on hold.
• Message Waiting Tone: When enabled, a stutter dial tone is played when first going off-hook and a
new message is waiting. The visual LED notification is always enabled for voicemail notification.
• Auto Answer: When enabled, it will automatically activate the speakerphone or headset when an
incoming call is received.
• Access Code Prefix: To simplify dialing from the Phonebook or Call Logs, enter a hunt group (9, 81-88)
that you would like the phone to use as aprefix to place calls using the specified hunt group. If direct
line access is enabled for the extension, then leave blank.
• Call Forwarding: is not supported directly by the TalkSwitch phone. Call forwarding is configured in
the TalkSwitch system for busy, no answer and DND conditions for the extension.
• Direct Call (Hotline/Warm-Line): When used with the TalkSwitch system, the feature is controlled by
the configuration in the software for this extension. No configuration is required.
• Direct Call: when enabled, places a call to a predefined destination automatically when the phone
goes off hook.
• Direct Call Number: defines the destination for a direct call.
• Direct Call Timer: sets a delay timer for Warm-Line operation. The timer specifies the period
before placing a direct call. The timer supports 1 second increments from zero (0) to ten (10)
seconds. For Hotline operation, set the timer to zero (0) seconds.
To modify parameters on the Call Preferences screen:
• Select the desired parameter and enter or select the new values.
• When complete, select the Save button to save the new values to the phone.
E V E R Y C A L L C O U N T S 4 1