Copying Non-Standard Sized Originals; Defining The Original Width - Oce 9800 User Manual

Copying non-standard sized originals

The scanner of the Océ 9800 system automatically detects the width of the
inserted original. For European sizes, for example, it detects whether the width
is A0, A1, A2, A3, A4, 500 mm, or 700 mm. The Océ 9800 system uses a
memory table that contains all standard width - standard length combinations
to predict the length of the original. The scanner also measures the real length
of each original while it is moved through the scanner.
If you are copying thick originals or originals in a carrier sheet, we
Note:
recommend that you use the Original Receiving Unit to ensure correct delivery
(see 'Original delivery after scanning' on page 45).
Defining the original width
To prevent information loss when copying a non-standard original, select
'non-standard' original width. The scanned width will then be larger than the
original width. You may also define the scanned width and length yourself, if
desired.

Defining the original width

Open the 'Special original' card in the 'Copy' section.
1
Press `Original width' to select the required setting:
2
Standard. This option must be used to copy a standard-sized original.
Non-standard. This option can be used to copy a non-standard-sized original.
The scanned width will be larger than the original width, to prevent
information loss.
Numeric. This option allows you to define the width of the original yourself,
using the higher/lower buttons or the numeric buttons.
Special copy jobs 69