Figure 60 Configuration > Wan > Setup - Prestige - Bridge Mode; Table 36 Configuration > Wan > Setup - Prestige - Bridge Mode - ZyXEL Communications VANTAGE CNM 2.0 User Manual

Figure 60 Configuration > WAN > Setup – Prestige – Bridge Mode
The following table describes the fields in this screen
Table 36 Configuration > WAN > Setup – Prestige – Bridge Mode
LABEL
Name
Mode
Encapsulation
Multiplex
Chapter 8 Configuration > WAN
DESCRIPTION
Enter the name of your Internet Service Provider, e.g., MyISP. This information
is for identification purposes only.
Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Select the method of encapsulation used by your ISP from the drop-down list
box. Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
Vantage CNM 2.0 User's Guide
118