Configuring Exceptions - HIKVISION DS-7300HFI-ST Series User Manual

User's Manual of DS-7300HFI-ST Series DVR
3. Select the alarm input to configure in the Alarm Input No. drop down menu on the upper left of
the menu. If all alarm inputs are to be configured with the same settings, select All from the list.
4. Select the Trigger Action for the external alarm input device. Normal Open or Normal Close can
be selected.
5. Select the PTZ Actions (only if a PTZ camera is configured on the DVR) to run when the alarm
input is triggered. Only one PTZ action can be selected per alarm input.
6. Select the Actions to run when the alarm input is triggered. Multiple actions can be selected per
alarm input. The actions available includes:
• Sound Audio Warning: DVR will sound an audio warning if alarm is triggered.
• Pop-up Image on Monitor: DVR will show the corresponding channel that is associated
with the trigger input.
Notify Surveillance Center: DVR will notify surveillance center when alarm is triggered.
•
Send Email: DVR will send an email out to the designated recipients when alarm is
•
triggered.
Trigger Alarm Output: DVR will trigger alarm output when input is triggered. Selecting
•
this option will enable the Alarm Output list, where the output to trigger can be selected.
7. Select the Save button to save the trigger settings and select Exit to return to the previous menu.
Selecting the Exit button without clicking Save will quit out of the menu without saving settings.

Configuring Exceptions

Actions can also be triggered when the DVR detects certain exceptions. To setup exception configuration:
1. Enter the Exception Configuration menu, shown in Figure 51 by going to Main Menu > System
Configuration > Exception Configuration.
2. Select the Exception Type to configure. The exception type includes:
• HDD Full: If selected, trigger action when HDD is full.
HDD Error: If selected, trigger action when errors on the HDD are detected.
•
• Network Failure: If selected, trigger action when a network failure is detected.
• IP Conflict: If selected, trigger action if an IP conflict is detected.
Illegal Login: If selected, trigger action when illegal logins are detected.
•
Figure 51 Exception Configuration Menu
62