HIKVISION DS-7300HFI-ST Series User Manual page 57

User's Manual of DS-7300HFI-ST Series DVR
2. Select the Serial Settings tab.
3. Select the camera to configure in the camera drop down menu on the upper left of the menu. If all
cameras are to be configured with the same settings, select All Cameras from the list.
4. Configure PTZ settings, including those of Baud Rate, Data Bit, Stop Bit, Parity, Flow Ctrl,
Protocol and Address according to the parameters of the PTZ camera(s).
5. Click the Save button to save current settings.
To test and verify PTZ settings:
1. Enter the PTZ Configuration menu, shown in Figure 45 by going to Main Menu > System
Configuration > PTZ Configuration.
2. Select the On Camera Settings tab.
3. Select the camera to test in the camera drop down menu.
Figure 44 PTZ Configuration Menu
Figure 45 PTZ Configuration
57