Configuring Capture Schedule - HIKVISION DS-7300HFI-ST Series User Manual

User's Manual of DS-7300HFI-ST Series DVR
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be
configured with the same settings, select All Cameras from the list.
3. The settings available to configure for each video output includes:
 Capturing Mode: Select the capturing mode to Normal of Event.
 Picture Resolution: Select the picture resolution in the Resolution drop down menu.
The options for the capture resolution include 4CIF, CIF and QCIF.
 Picture Quality: Select the picture quality to High, Medium of Low in the drop
down menu.
 Capturing Interval: Select the time period in second between two capturing actions.
Note:
The interval is the time period between two capturing actions. You can configure the parameters from 1s
to 5s.

Configuring Capture Schedule

Set the capture schedule, then the camera will automatically start/stop capturing according to the schedule.
1. Enter the Capture Schedule interface, shown in Figure 27 by going to Main Menu > Recording
Configuration > Capture Schedule Settings.
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be
configured with the same settings, select All Cameras from the list.
3. Check the Enable checkbox to enable the capture schedule. If the checkbox is unchecked, the
capture schedule will be disabled.
4. Select a day between Monday to Sunday or Holiday to configure schedule for.
5. Setup time periods for schedule. If the 24HR checkbox is checked, recording will occur over the
entire day. To setup multiple time periods, uncheck 24HR and enter the Start and Stop Time for
the selected day. The start and stop time are listed using a 24 hr cycle (i.e. 18:00 is equivalent to
6:00pm).
Figure 27 Configure Capture Schedule
39