HIKVISION DS-7300HFI-ST Series User Manual page 82

User's Manual of DS-7300HFI-ST Series DVR
To view network traffic:
1. Enter the Network Detection menu, shown in Figure 70 by going to Main Menu > Maintenance >
Network Detection.
2. Select the Traffic tab and you can view the sending rate and receiving rate information on the
interface. The traffic data is refreshed per second.
To configure network detection:
1. Enter the Network Detection menu, shown in Figure 70 by going to Main Menu > Maintenance >
Network Detection.
2. Select the Detection tab to enter the Network Detection menu.
3. Enter the target address in the text field of Target Address.
4. Click the Test button to start testing network latency and packet loss. The testing result will pop
up on the window. If the testing is failed, the error message box will pop up.
To export network packet:
By connecting the DVR to network, the captured network data packet can be exported to USB-flash disk,
SATA/eSATA CD-RW and other local backup devices.
1. Enter the Network Detection menu, shown in Figure 70 by going to Main Menu > Maintenance >
Network Detection.
2. Select the Detection tab to enter the Network Detection menu.
Note: Click the Refresh button if the connected local backup device cannot be displayed. When it
fails to detect the backup device, please check whether it is compatible with the DVR. You can
format the backup device if the format is incorrect.
3. Click the Export button to start exporting.
4. After the exporting is complete, click OK to finish the packet
Figure 70 Network Detection
export.
82