Table of Contents
Advertisement
User's Manual of DS-7300HFI-ST Series DVR
2. Select the camera to setup video loss detection in using the camera drop down menu on the upper
left of the menu. If all cameras are to be configured with the same settings, select All Cameras
from the list.
3. Click Enable Video Loss Detection.
4. Select Actions to take if video loss is detected. More than one action can be selected per channel.
These actions include:
•
Sound Audio Warning: DVR will sound an audio warning if video loss is detected.
•
Pop-up Image on Monitor: DVR will show the corresponding channel that is associated
with the video loss channel.
•
Notify Surveillance Center: DVR will notify surveillance center when video loss is
detected.
Send Email: DVR will send an email out to the designated recipients when video loss is
•
detected.
•
Trigger Alarm Output: DVR will trigger alarm output when video loss is detected.
Selecting this option will enable the Alarm Output list, where the output to trigger can be
selected.
5. Select the Save button to save the privacy zones settings and select Exit to return to the previous
menu. Selecting the Exit button without clicking Save will quit out of the menu without saving
settings.
Configuring OSD Settings
On Screen Display (OSD) settings can be configured in the OSD Configuration menu. The OSD is shown
in each display in Live Feed and Playback mode.
To configure OSD settings:
1. Enter the OSD Configuration menu, shown in Figure 56 by going to Main Menu > Cameras
Setup > OSD Configuration.
Figure 55 Video Loss Detection Menu
68
Advertisement
Table of Contents
