Configuring An Advanced Recording Schedule - HIKVISION DS-7300HFI-ST Series User Manual

User's Manual of DS-7300HFI-ST Series DVR
Note:
For holiday settings, you can refer to Page 37.

Configuring an Advanced Recording Schedule

An advanced recording schedule allows you to schedule multiple time periods per day for recording as
oppose to a single time period of a quick recording schedule. Setting up an advanced recording schedule
will allow you to further conserve disk space by recording only during the time periods you would like to
record at.
To setup an advanced recording schedule:
1. Enter the Advanced Schedule Configuration menu, shown in Figure 22 by going to Main Menu >
Recording Configuration > Advanced Schedule Configuration.
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be
configured with the same settings, select All Cameras from the list.
3. Check the Enable checkbox to enable the recording schedule. If the checkbox is unchecked, the
recording schedule will be disabled.
4. Select a day between Monday to Sunday or Holiday to configure schedule for.
5. Setup time periods for schedule. If the 24HR checkbox is checked, recording will occur over the
entire day. To setup multiple time periods, uncheck 24HR and enter the Start and Stop Time for
the selected day. The start and stop time are listed using a 24 hr cycle (i.e. 18:00 is equivalent to
6:00pm).
6. Select recording type under Type for selected day of the week. Recording type includes
Continuous for continuous recording or On Event for recording when an event is triggered (i.e.
from detected motion) for the selected time period and click Add.
7. If there are scheduling errors detected, such as overlapping time periods, error messages such as
those shown in Figure 23 will appear.
Figure 22 Advanced Schedule Configuration Menu
36