Throttle Position Sensor Replacement And Adjustment - Yamaha YZ250F(V) Owner's Service Manual

THROTTLE POSITION SENSOR SYSTEM
2
1
1
b a
2
3. Inspect:
• Throttle position sensor coil variable
resistance
Check that the resistance in increased as
the throttle grip is moved from the full
close position to the full open position.
Out of specification → Replace.
Tester (+) lead → Yellow lead 1
Tester (–) lead → Black lead 2
Throttle position sen-
sor coil variable
resistance
Full
closed
Zero ~ 3 kΩ
at 20 °C
(68 °F)
THROTTLE POSITION SENSOR
REPLACEMENT AND ADJUSTMENT
1. Remove:
• Throttle position sensor coupler
• Carburetor
2. Remove:
• Screw (throttle position sensor) 1
• Throttle position sensor 2
NOTE:
Loosen the screws (throttle position sensor)
using the T25 bit.
3. Replace:
• Throttle position sensor
4. Install:
• Throttle position sensor 1
• Screw (throttle position sensor) 2
NOTE:
• Align the slot a in the throttle position sensor
with the projection b on the carburetor.
• Temporarily tighten the screws (throttle posi-
tion sensor).
6 - 9
–
ELEC
Tester
selector
position
Full
opened
kΩ × 1
4 ~ 6 kΩ at
20 °C
(68 °F)
+