Installing The System Board,Dc-In,Rj45 Cable And Blue-Tooth Card - Toshiba NB100 Maintenance Manual

4.7 System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card
Installing the System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card
Install the System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card according to the
following procedures and Figure 4-15, 4-16.
NOTE:
Be careful of the eject button for the PC card. It can be damaged when installing the
system board. Make sure it is pushed in.
1. Seat the system board in the correct position.
2. Secure the system board with one M2.5 x 5 and one M2.5 x 3.5 black flat-head
screws.
3. Seat the Blue-Tooth card in the correct position.
4. Secure the Blue-Tooth card with one M 1.6 x 4 black flat-head screw.
5. Connect the Blue-Tooth cable to CN10 on the system board.
6. Connect the RJ-45 cable to CN511 on the system board.
7. Connect the DC-IN cable to CN5 on the system board.
8. Seat the MIC rubber in the correct position.
TOSHIBA NB100 Maintenance Manual
4 Replacement Procedures
4-29