Configuring The Maximum Number Of Ospf Routes; Configuring The Maximum Number Of Ecmp Routes - HP 6125G Configuration Manual

calculated cost is greater than 65535, the value of 65535 is used. If the calculated cost is less than
1, the value of 1 is used.
If the cost value is not configured for an interface, OSPF computes the interface cost automatically.
To configure an OSPF cost for an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure an OSPF cost
for the interface.
To configure a bandwidth reference value:
Step
1. Enter system view.
2. Enter OSPF view.
3. Configure a bandwidth
reference value.

Configuring the maximum number of OSPF routes

Step
1. Enter system view.
2. Enter OSPF view.
3. Configure the maximum
number of OSPF routes.

Configuring the maximum number of ECMP routes

Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Step
1. Enter system view.
Command
system-view
interface interface-type
interface-number
ospf cost value
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
bandwidth-reference value
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
maximum-routes { external | inter | intra }
number
Command
system-view
75
Remarks
N/A
N/A
Optional.
The default cost depends on the interface
type: 1 for a VLAN interface; 0 for a
loopback interface; computed according
to the bandwidth for other interfaces.
Remarks
N/A
N/A
Optional.
The value defaults to 100
Mbps.
Remarks
N/A
N/A
Optional.
The number varies with
devices.
Remarks
N/A